Description:
Excessive shrinking and/or shrinkage can be defined as an extreme decrease in the dimensions of a molded part after it has cooled to room temperature.
Possible Causes & Remedies:
Machine Cause
◇ BARREL TEMPERATURE TOO HIGH
Remedies: Decreasing the barrel temperature allows the molecules and voids to expand and contract normally and provide consistent shrinkage values. Shrinkage is impossible to predict accurately, but keeping the material and mold temperatures at the right settings (as recommended by the material suppliers) will minimize the effective shrinkage.
◇ INSUFFICIENT INJECTION PRESSURE OR TIME
Remedies: Increase the amount of pressure or the time applied. Upon initial startup, the mold should be filled incrementally starting with intentional short shots (if the mold design allows) and progressively increasing pressure shot-by-shot until the mold is filled and packed properly. Then, parts should be inspected for critical dimensions. If the mold is new, and dimensions are incorrect, the mold should be returned to the moldmaker for adjustments. If the mold has already been in production and the dimensions are wrong, process parameters can be adjusted to make the part shrink less or more, whichever is required.
◇ INADEQUATE COOLING TIME
Remedies: Adjust the cooling time portion of the cycle. It is true that longer cycles make the part more expensive but there is a minimum amount of time required for the resin to form a proper skin. It depends on what material is being molded. A general rule-of-thumb for a part with a wall thickness of 0.100‘‘, the cooling time should be 20 seconds. The overall cycle would then be 25-30 seconds.
◇ INSUFFICIENT CUSHION AND/OR HOLD TIME
Remedies: Maintain a cushion that is somewhere between 1/8‘‘ and 1/4‘‘ at the end of the injection stroke. This provides something against which hold pressure can be applied. The amount of time for holding pressure should be long enough for the gate to freeze, normally 3-4 seconds.
◇ EXCESSIVE NON-RETURN VALVE CLEARANCE
Remedies: Inspect the non-return valve mechanism and replace worn or damaged components. This wear is normal but is accelerated by molding materials that have reinforcements (such as glass) in them. The valve should be inspected at least every three months.
Mould Cause
◇ MOLD TEMPERATURE TOO HIGH
Remedies: Increase the mold temperature to the point at which the material has the proper flow and packs out the mold with maximum fill. Start with the material suppliers recommendations and adjust accordingly. Allow 10 cycles for every 10-degree change for the process to re-stabilize.
◇ SMALL GATES AND/OR RUNNERS
Remedies: Examine the gates and runners to optimize their size and shape. Do not overlook the sprue bushing as a long sprue may solidify too soon. Use a heated bushing or extended nozzle to minimize sprue length. Ask the material supplier for data concerning gate and runner dimensioning for a specific material and flow rate.
◇ IMPROPER GATE LOCATION
Remedies: Relocate or redesign the gate so that the molten plastic is directed against an obstruction such as a core pin. This will cause the material to disperse and continue to flow instead of slowing down.
Material Cause
◇ IMPROPER FLOW RATE
Remedies: Utilize a material that has the stiffest flow possible without causing non-fill. Contact the material supplier for help in deciding which flow rate should be used for a specific application.
Operator Cause
◇ INCONSISTENT PROCESS CYCLE
If possible, operate the machine on automatic cycle, using the operator only to interrupt the cycle if an emergency occurs. Use a robot if an ``operator‘‘ is really necessary. And, instruct all employees on the importance of maintaining consistent cycles.